Charlotte is the biggest metro in our service area, and we want to be upfront about something: A&S Brushworks is not a Charlotte company. We're based in Rock Hill, SC, about twenty minutes south on I-77. We cross the state line into Mecklenburg County most weeks because there's steady demand for forestry mulching in and around Charlotte, and we've built the job flow to make it efficient. We cluster Charlotte-area work so that when the Kubota SVL 97-3 is on the trailer heading north, we're hitting two or three jobs in the same trip.
We're not working in uptown or the dense urban core — that's not forestry mulching territory. Our Charlotte work is in the outer neighborhoods, the suburban edges, and the parcels that still have real trees on them. Overgrown residential lots in south Charlotte, wooded acreage off Brookshire, estate properties along the Providence Road corridor, vacant parcels waiting on a new build. Charlotte has more wooded ground than people realize once you get past the commercial strips, and that's where we come in.
Residential lot clearing and overgrown properties
The bulk of our Charlotte work is residential. Homeowners call because the back half of the lot has become a wall of privet, sweetgum, volunteer pine, and bramble. They haven't been able to use that part of the yard in years. One pass with the FAE forestry mulcher and the usable yard doubles in size. We handle trees up to 8 inches in diameter and leave a clean mulch layer on the ground — no burn piles, no debris hauling, no torn-up topsoil.
We also clear overgrown vacant lots for owners who are prepping to sell or build. A lot of Charlotte's growth is infill development on parcels that have been sitting idle for a decade or more, and those lots tend to be thick with undergrowth by the time someone decides to do something with them. Forestry mulching gets the lot cleared in a day or two without the erosion problems that come with a bulldozer scrape.
New-build site prep and commercial clearing
For builders and developers working on Charlotte-area lots, we handle the vegetation clearing phase before grading starts. We'll clear the building footprint, open the driveway line, and mulch down the understory while leaving the topsoil intact. The builder comes in behind us to a cleaner starting point than a dozer-and-burn approach would leave, and the erosion control plan is simpler because we didn't strip the ground bare.
We take on some commercial clearing work in Charlotte as well — small parcels, utility access runs, and overgrown buffer strips between commercial properties and residential neighborhoods. If the scope is under five acres and the stems are within our 8-inch range, we can usually handle it. Anything bigger or heavier and we'll tell you straight — you need a larger machine than ours.
HOAs and the Charlotte permitting landscape
Charlotte is HOA country. A significant share of our residential calls come from homeowners in covenant-controlled neighborhoods, and we've learned to ask the right questions before we schedule. We'll ask whether your HOA has approved the work, whether there are restrictions on removing trees over a certain caliper, and whether you need documentation from us for the architectural review board. If you need our insurance certificate or a scope letter, we send it.
On the city side, Charlotte has a tree protection ordinance that applies to certain removals on certain lot sizes. The specifics depend on your zoning and the scope of the project. We'll flag anything obvious we see on a site visit, but permit responsibility stays with the property owner. For straightforward brush removal and understory mulching — which is most of what we do — permits usually aren't required, but it's worth a phone call to the city if you're unsure.
Pricing and scheduling for Charlotte jobs
Our standard rate is $1,500 to $5,000 per acre, and Charlotte jobs tend toward the smaller end of the scale — quarter-acre and half-acre residential lots rather than full-acre rural tracts. For small parcels we quote a flat day rate or half-day minimum, because the real cost on any metro job is mobilization, not mulching hours. We'll give you an honest number over the phone if you send us the address and a few photos, and we'll come walk the property in person for anything over a quarter acre or anything with tight access.
We group Charlotte work into blocks so that when the machine is already in Mecklenburg County, we can stack jobs. That keeps our pricing competitive with contractors who yard out of Charlotte itself. If we're already booked on the SC side of the calendar, you might be a week or two out rather than same-week — but for urgent work like storm damage, a closing deadline, or an HOA deadline, call us and we'll see what we can rearrange. Corey and Sam handle every quote personally — (336) 467-4572.
Questions about Charlotte jobs
No. A&S Brushworks is based in Rock Hill, SC, about twenty minutes south of Charlotte on I-77. We cross the state line into Mecklenburg County most weeks and treat Charlotte as part of our core service area, not a special trip. We cluster Charlotte jobs together to keep pricing competitive.
Our standard range is $1,500 to $5,000 per acre depending on tree density, stem size, terrain, and access. Most Charlotte residential jobs are smaller than a full acre, so we typically quote a flat day rate or half-day minimum. Send us the address and a few photos and we'll give you a real number over the phone.
If your property is in a covenant-controlled neighborhood, yes — and we'll ask about it before we schedule. We need to know whether your HOA has signed off, whether there are restrictions on tree removal by caliper, and whether the architectural review board needs anything in writing from us. We'll provide insurance certificates and scope letters as needed.
Also in Mecklenburg County